[Retire on Nov.30, 2022] Updated Fortinet NSE7_SDW-6.4 Exam Material

dumps2022-09-02T02:39:04+08:00

Fortinet NSE 7 NSE7_SDW-6.4 exam will be retired on November 30, 2022, and the new upgrade test is NSE7_SDW-7.0. If you decide to take the NSE7_SDW-6.4 exam to get Fortinet NSE 7 certification, please take it before the retirement date. We just updated the Fortinet NSE7_SDW-6.4 exam material, which can guarantee you success. Free updated Fortinet NSE7_SDW-6.4 exam material is below.

Page 1 of 2

1. Refer to the exhibit.

Based on the output shown in the exhibit, which two criteria on the SD-WAN member configuration can be used to select an outgoing interface in an SD-WAN rule? (Choose two.)

Set priority 10.

Set cost 15.

Set load-balance-mode source-ip-ip-based.

Set source 100.64.1.1.

2. Which statement is correct about the SD-WAN and ADVPN?

ADVPN interface can be a member of SD-WAN interface.

Dynamic VPN is not supported as an SD-Wan interface.

Spoke support dynamic VPN as a static interface.

Hub FortiGate is limited to use ADVPN as SD-WAN member interface.

3. What would best describe the SD-WAN traffic shaping mode that bases itself on a percentage of available bandwidth?

Per-IP shaping mode

Reverse policy shaping mode

Interface-based shaping mode

Shared policy shaping mode

4. Refer to the exhibit.

Based on the exhibit, which statement about FortiGate re-evaluating traffic is true?

The type of traffic defined and allowed on firewall policy ID 1 is UD

FortiGate has terminated the session after a change on policy ID 1.

Changes have been made on firewall policy ID 1 on FortiGate.

Firewall policy ID 1 has source NAT disabled.

5. What are two roles that SD-WAN orchestrator plays when it works with FortiManager? (Choose two)

It configures and monitors SD-WAN networks on FortiGate devices that are managed by FortiManager.

It acts as a standalone device to assist FortiManager to manage SD-WAN interfaces on the managed FortiGate devices.

It acts as a hub FortiGate with an SD-WAN interface enabled and managed along with other FortiGate devices by FortiManager.

It acts as an application that is released and signed by Fortinet to run as a part of management extensions on FortiManager.

6. Refer to exhibits.

Exhibit A.

Exhibit B.

Exhibit A, which shows the SD-WAN performance SLA and exhibit B shows the health of the participating SD-WAN members.

Based on the exhibits, which statement is correct?

The dead member interface stays unavailable until an administrator manually brings the interface back.

The SLA state of port2 has exceeded three consecutive unanswered requests from the SLA server.

Port2 needs to wait 500 milliseconds to change the status from alive to dead.

Check interval is the time to wait before a packet sent by a member interface considered as lost.

7. Refer to the exhibit.

Which two statements about the status of the VPN tunnel are true? <Choose two)

There are separate virtual interfaces for each dial-up client.

VPN static routes are prevented from populating the FortiGate routing table.

FortiGate created a single IPsec virtual interface that is shared by all clients.

100.64.3.1 is one of the remote IP address that comes through index interface 1.

8. Refer to the exhibit.

Which two statements about the debug output are correct? (Choose two)

The debug output shows per-IP shaper values and real-time readings.

This traffic shaper drops traffic that exceeds the set limits.

Traffic being controlled by the traffic shaper is under 1 Kbps.

FortiGate provides statistics and reading based on historical traffic logs.

9. What are the two minimum configuration requirements for an outgoing interface to be selected once the SD-WAN logical interface is enabled? (Choose two)

Specify outgoing interface routing cost.

Configure SD-WAN rules interface preference.

Select SD-WAN balancing strategy.

Specify incoming interfaces in SD-WAN rules.

10. Refer to exhibits.

Exhibit A.

Exhibit B.

Exhibit A shows the traffic shaping policy and exhibit B show: the firewall policy

FortiGate is not performing traffic shaping as expected basi on the policies shown in the exhibits.

To correct this traffic shaping issue on FortiGate, what configuration change must be made on which policy?

The shaper mode must be applied per-IP shaper on the traffic shaping policy

The application control profile must be enabled on the firewall policy.

The web filter profile must be enabled on the firewall policy

The URL category must be specified on the traffic shaping policy

Page 2 of 2

11. Which two statements reflect the benefits of implementing the ADVPN solution to replace conventional VPN topologies? (Choose two)

It creates redundant tunnels between hub-and-spokes, in case failure takes place on the primary links.

It dynamically assigns cost and weight between the hub and the spokes, based on the physical distance.

It ensures that spoke-to-spoke traffic no longer needs to flow through the tunnels through the hub.

It provides direct connectivity between all sites by creating on-demand tunnels between spokes.

12. Refer to the exhibit.

Multiple IPsec VPNs are formed between two hub-and-spokes groups, and site-to-site between Hub 1 and Hub 2 The administrator configured ADVPN on the dual regions topology

Which two statements are correct if a dynamic site-to-site tunne1 between Toronto and London has been established? (Choose two)

B. auto-discovery-sender is enabled on the ingress VPN interfaces on hubs

C. tunnel-search IS set to phase 2 quick mode selectors

D. add-route is enabled to install static routes on hub devices

E. auto-discovery-forwarder IS enabled on all VPN interfaces

13. Refer to the exhibit.

Which two statements about the debug output are true? (Choose two)

The debug output shows per-IP shaper values and real-time readings.

FortiGate provides statistics and reading based on historical traffic logs.

Traffic being controlled by the traffic shaper is under 100 KB/s.

This traffic shaper drops traffic that exceeds the set limits.

14. Which statement defines how a per-IP traffic shaper of 10 Mbps is applied to the entire network?

FortiGate allocates each IP address a maximum 10 Mbps of bandwidth.

Each IP is guaranteed a minimum 10 Mbps of bandwidth

A single user uses the allocated bandwidth divided by total number of users.

The 10 Mbps bandwidth is shared equally among the IP addresses.

15. Which CLI command do you use to perform real-time troubleshooting for ADVPN on either a hub or a spoke FortiGate?

diagnose sys virtual-wan-link service

get router info routing-table

diagnose debug application ike

get ipsec tunnel list

16. Refer to exhibits

Exhibit A shows the system interface with the static routes and exhibit B shows the firewall policies on the managed FortiGate

Based on the FortiGate configuration shown in the exhibits, what are two issues you might encounter when creating an SD-WAN interface on port1 and port2? {Choose two)

Member interfaces that are administratively down

Member interface that have IP address of 0.0.0.0/0.0.0.0

Member interfaces that are physical interfaces as well as VLAN aggregate, and iPsec interfaces

Member interfaces that are referenced by any other configuration element

[Retire on Nov.30, 2022] Updated Fortinet NSE7_SDW-6.4 Exam Material

[Retire on Nov.30, 2022] Updated Fortinet NSE7_SDW-6.4 Exam Material

Share this post

Leave a Reply Cancel reply

Related Posts